Main page » Cable and pipe detection » Cable and pipe locating » Locating receivers

Locating receivers

A receiver is the central tool for fast and reliable utility location in network and civil engineering. Our locating receivers can operate either in passive modes (e.g. power/RF) or in active locating together with a transmitter or signal generator. This provides you with clear readings for a swift workflow directly in the field.

Performance features of the locating receivers

The receivers help you to reliably trace cables and confirm their position with full traceability:

Depth display & directional guidance: identify the route, check the depth and confirm hits with certainty
Peak/Null & compass: reliable antenna alignment and clear signal guidance
Ready for the field: robust construction, intuitive operation as well as audible and visual feedback

Passive and active locating combined

In passive mode, the receivers detect existing signals such as power or radio frequency (RF) fields – ideal for an initial overview of the underground. In active locating, a defined signal is applied to the target line together with a transmitter, allowing its route and depth to be determined precisely and verifiably.

1 to 12 (from a total of 12)

What makes a good receiver?

A high-performance receiver combines high sensitivity with intelligent signal processing. This ensures that line signals are reliably separated from interference fields, depth values are displayed consistently and routes are tracked clearly. In cable detection and locating technology in particular, this combination determines whether you can locate underground lines reliably and precisely.

Typical functions of a receiver

Modes: passive (power/broadcast fields), active (with signal generator) and sonde
Depth & current: depth measurement and current direction for reliable route identification
Guidance: left/right indication, arrows and audio guidance
Signal processing: auto/manual gain as well as notch and band filters
Documentation: optional data logging, GPS and Bluetooth
Ergonomics: well-balanced weight, bright display and IP protection

Selection guide: finding the right receiver

Which receiver suits your work depends primarily on your application profile. The following criteria will help you make your decision:

Application profile: pre-locating, route tracing, service connection or fault finding
Frequency package: suitable active and passive bands as well as sonde support
Accuracy: reliable depth and current direction at typical ground depths
Environment: filters and power for urban interference fields and multiple routes
Workflow: display, logging and connectivity as required

Practical tips for locating

Always check several modes (passive and active) before excavation
When using active locating, ensure a good return current path
Verify the route in sections and document the readings

Frequently asked questions about the receiver

What is the difference between a receiver and a complete set?

The receiver is the locating device. A complete set additionally includes a signal generator and often further accessories.

Which frequency is the right one?

Low frequencies (512/640 Hz) are suitable for deep, long lines; 8–9 kHz for mixed environments; 33 kHz for short or interrupted conductors.

How accurate are depth readings?

Accuracy depends on signal quality, alignment and ground conditions. Clean coupling and correct device settings improve the result.

Can I locate plastic pipes?

Only with a tracer wire or sonde. Plastic-only lines without a conductor require a sonde or a traceable push cable.

Frequently asked questions

General1

Who are the products intended for?

Our range is aimed at specialist companies and organisations in the utilities and civil-engineering sector – including municipal utilities, water suppliers, energy utilities (EVU), construction companies, municipalities, telecommunications companies, engineering offices and technical service providers.